User guide

Using SNMP
396 MAXCS ACM 6.5 Administration Manual
Configure the parameters:
• Check Enable sending SNMP traps.
• Enter the SNMPv3 server address.
• Enter the SNMPv3 server port.
• Select a security level:
• No Authentication and No Privacy
• With Authentication but No Privacy
• With Authentication and Privacy
• Select an Authentication Method, and enter a password
• Select a Privacy Protocol, and enter a password.
• Configure traps:
• Memory usage exceeds This trap is sent when MAXCS detects that the lowest
virtual memory usage exceeds a specified percentage of physical memory
configuration within a 10-minute duration. Default value is 80%. The next trap
will be sent after the condition is cleared then occurs again. The minimum
duration between any two consecutive traps is 30 minutes
• Average CPU utilization exceeds This trap is sent when MAXCS detects its
average CPU utilization exceeds a specified percentage in any 10-minute
duration. Default value is 80%. The next trap will be sent after the condition is
cleared then occurs again. The minimum duration between any two consecutive
traps is 30 minutes