User guide

Configuring an Extension as a Mobile Extension
254 MAXCS ACM 6.5 Administration Manual
within this Group ID when the system calls out to this mobile extension
number.
When the mobile extension user calls into the system, any mobile trunk port
can answer the call, verify caller ID, and play a dial tone to the mobile
extension user.
Dedicated—Only analog trunks can be dedicated mobile trunks. When
selected, you need to assign a mobile trunk port to this mobile extension. You
have the option to disable caller ID verification if a mobile trunk port is
dedicated to this mobile extension. The mobile extension user will hear a dial
tone when calling into this specific trunk port. Use the Browse button (…) to
select the desired mobile trunk.
Figure 5. Mobile Trunks dialog box
• In the Phrase panel, you have three options: You can select either Press Any
Key To Answer Call or Play Phrase After Answered. And you can select
Play Phrase Before Dial Tone. You can use the Apply button to apply
selections in this panel to other mobile extensions.
Note: For mobile extensions running MaxMobile Communicator, you should
clear all three check boxes in the Phrase panel.
• Press Any Key To Answer Call—when a call is answered by this mobile
extension user, the system will play the following phrase for the mobile
extension user: “To accept this call, please press any digit.” The user must
press any key within 3 seconds to connect the call; otherwise, it will time out
and the call will be treated as an agent/extension RNA and will be routed
according to its workgroup/extension setting.
If there is a network error or a mobile extension trunk is not available, RNA
handling is applied to the caller. Therefore, it is suggested that you don’t
check the Set RNA Agent Logout option for the group that contains the
mobile extension as an agent (Workgroup Configuration, Call Handling
tab).