User guide
Configuring the AltiGen IP Phone
MAXCS ACM 6.5 Administration Manual 235
Parameter Description
General
Lets you specify the IP address of the MAXCS system the IP
phone is connected to. Also see “Configuring Auto-Discovery of
Server IP Address” on page 241. The version of firmware
associated with the IP phone is automatically displayed in the
Version field.
To protect the configuration on the IP phone, check the Enable
Configure Password check box and assign a numerical
password. When the user presses the Menu button on the IP
phone to access the phone configuration menu, the user will
need to enter the assigned password. You can use this check
box for two purposes:
• If you publish the configuration password to the user, only
the phone user would be able to change the phone
configuration.
• If you do not publish the configuration password, you can
block the phone user from changing the phone
configuration.
Default
Trunk
Access
Code
Lets you set the digit required to enable a user to return an
outside call from the Call Log. The default trunk access code
can be the route access code, if it is set in MaxAdmin.
Debug This is for debugging the IP phone using Telnet. You need to
enter a Diagnostic password when logging in to MaxAdmin
(before you enter your Admin password) to enable this
configuration.