User guide

Chapter 4: System Configuration

MAXCS ACC 6.7.1 Administration Manual

To set up a First Digit Translator entry, select the check box (to

the left of 1-9, * or #), then enter the desired digits. When a box is

checked, the digit preprocessor will replace the first digit 1-9, * or

# that user dials with the digits indicated in the corresponding field.

In the above example, if a user dials “*”, the system replaces this

with “911”.

Note: This feature is for internal extension users only. It does not

support dialing out from voice mail. Improper configuration may

cause conflict with the system numbering plan. Be sure to fully test

any configuration change in this area before going “live.”

Extension Dialed Digit Translator

This feature is intended for, but not limited to, allowing a remote IP

extension to make an emergency call (911) through AltiServ. If Al-

tiServ is in a different location than the IP extension, the emergency

call can be routed to the emergency center where the IP extension

is located.

Figure 14.

Figure 15. Extension Call Routing

To set up an Extension Dialed Digit Translator entry:

1. Select Extension Dialed Digit Translator from the Select

Digit Translator list.

2. In the Extensions Group field, use the Add button to create and

select an extension group that the Extension Dialed Digit Trans-

lator will apply to.

Parameter Description