User guide

Chapter 4: System Configuration
MAXCS ACC 6.7.1 Administration Manual
43
Distinctive Ring
Enables users to distinguish between internal, external, and
operator calls by the way the phone rings:
• Enable Distinctive Ring – Establishes a short double ring
cadence for internal calls and a normal, single ring for ex
-
ternal calls. Unselected, both rings are normal.
• Enable Operator Priority Ringing – Produces a long sin-
gle ring between short pauses on calls to the operator.
• Enable Workgroup Priority Ringing – Produces a short
single ring between short pauses on calls to the work
-
group.
System Home Area Code
Area code for the system location.
Note: This field cannot be blank in the U.S. and Canada.
Conference Bridge Op-
tion
Selected, conference calls will end when all internal lines have
disconnected from the conference bridge.
Not selected, the conference connection can continue be-
tween outside parties, even after all internal parties have dis-
connected.
System Main Number
The main system telephone number, which is sent to the pag-
er’s display when a user’s messaging options are configured
to call a pager. This number will be used by a PRI trunk as the
outbound caller ID in the event that no number is assigned in
the trunk Phone Number, 10-digit DID, or extension Transmit
CID field.
Note: This field cannot be blank.
PRI Calling Number
Check the check box to send a caller’s caller ID when the call
is going through one-number access (ONA) or when the call
is being forwarded.
System Call Park
• Timeout, Ring Back in
... Minutes
• Play Greeting Phrase
System Call Park (#41) allows the extension user to park a
call, then pick up the call from another extension. If the call
is forgotten, the Timeout sets the number of minutes a call
remains parked before the user’s extension is rung again. To
the caller, the call park sounds like being put on hold.
Valid entry: 1 - 60 minutes.
Select a greeting that the caller will hear before being placed
on hold.
Operator Extension and
Group Members
Select the extension to be used by the system operator. If the
extension number you select is a workgroup or a hunt group,
member extensions will show up in the Group Members box.
The operator extension is used in the following applications:
• Trunk in call routing
• DNIS in call routing
• Auto Attendant
Parameter Description