User guide

Chapter 3: Getting Around MaxAdministrator
MAXCS ACC 6.7.1 Administration Manual 37
• Jitter – Shows the average length of delay per voice packet in milliseconds. This
number can be used to measure the quality of service on the network that connects
the source and destination sites. Under 100 milliseconds is good, while a higher
figure indicates a longer than average delay. (See
“Setting VoIP Codec Profiles” on
page 302 for more detailed information on jitter.)
• Local Ports – Shows the local RTP/RTCP port for the voice stream
• Remote IP Address:Port – Shows the remote RTP port for the voice stream
Bottom part of the window
Shows information about the MeetMe 30-party conference bridge:
• Gateway ID of the 30-party conference board (for example, 00)
• MeetMe Conference Bridge ID (from 00:00 to 00:09)
• Number of members currently participating in a conference using each bridge
Note: Each system can have only one 30-party MeetMe conference board.
Setting the Refresh Interval
The Current Resource Statistics window is updated according to the Refresh Inter-
val configuration. By default, the Refresh Interval is set to refresh the data in the win-
dow every 5 seconds. To change the refresh interval, click the Refresh Interval button
at the top of the window, and set the refresh interval to a number of seconds up to one
minute. To set the time to 0 is to turn off the refresh interval.
Assigning Seat-Based Client Licenses
Most MAXCS client products require either session- or seat-based licenses. You may
have purchased both types. A session license allows a certain number of extensions to
use a client product. If you have purchased seat licenses so that particular extensions
always have access to the client product, those extensions must be assigned to the client
product in MaxAdmin. If an extension is not assigned to a product, that extension may
not be able to use the client product. You may have seat-based licenses for the following
MAXCS client products:
• MaxCommunicator
• MaxOutlook (uses MaxCommunicator license)
• MaxAgent
• MaxSupervisor
• MaxMobile Communicator
• AltiConsole
• IP Talk
• TAPI
• Integration Connector
• MaxCall
Assign extensions to seat-based licenses in the Client SEAT License Management config-
uration screen (License > Client SEAT License Management).