User guide

Chapter 3: Getting Around MaxAdministrator
34 MAXCS ACC 6.7.1 Administration Manual
The radio button to the left of each extension number is green when the extension is
idle, and red when the extension is not ready or in use. The Location number (for ex-
ample, 01:0005) identifies the card logical ID and port (channel) number on the board.
For example, in location 01:0005, the card logical ID is 1 and the port number is 005.
If an IP Extension is logged on, the location will also show the IP address.
The Reset button resets the selected extension to the idle status. You’ll be asked to
confirm the reset.
You can click the Reset button without selecting an extension, and then type in the
extension number for the extension to reset.
Trunk View Window
The Trunk View window shows the state of all assigned trunks.
Right-click a trunk to
display its physical
location or to open a
trunk line properties
window specific to the
selected trunk.
Figure 5. Trunk View window
The radio button to the left of each trunk location is green when the trunk is idle, and
red when the extension is not ready or in use. The location format is logical board
ID:channel—for example, channel 3 on the board in logical board ID 9 is location 09:03.
The Type, Status and Duration of trunk use is also displayed.
Note: The Duration field displays the duration of the trunk only if the call is connected
after MaxAdmin is started. The field will be empty if the trunk is idle, not ready,
out of service, or the call was connected prior to MaxAdmin being launched.
Double-click a trunk location to open the configuration window for the selected trunk.
The Reset button resets the selected trunk(s) to the idle status if the trunk is connected
to a carrier. You’ll be asked to confirm the reset, and a status message will tell you if
the reset was successful.
Call Log View Window
The Call Log View window displays the line and trunk traffic history.