User guide

MAXCS ACC 6.7.1 Administration Manual 389
Figure 175. Signaling Layer
6. In the E1 Channel Configuration dialog box, configure the following fields:
• Set Calling Party Category to—The Calling Party Category indicates the type of
calling party, (for example, operator, pay phone, priority, ordinary subscriber).
Select 1, 2 or 3 (for ordinary subscribers, refer to Table 1 on page 390). If the
subscribed line is intended for other purposes, contact your CO for the proper
value.
• Add extra digits before caller ID—Consult your CO to find out if any extra
digits are needed.
• Incoming sequences—Select check box and configure the sequence according
to Table 1 on page 390.
• In-call signaling—Configure the in-call signaling value according to Table 1 on
page 390.
The circled fields in Figure 175 represent values that depend on your country and its
corresponding trunk property.
Note: Consult your CO to find out if caller ID digits are provided in the lines.