User guide

388 MAXCS ACC 6.7.1 Administration Manual
.
Figure 173. Physical Layer
Consult your CO for “Frame Type,” “Line Code,” or “Zero Code Suppression.”
Do not check the System Clock Master check box because the CO is a clock pro-
vider, and the AltiGen system is synchronized to the CO. If all configurations are
correct, the status should be shown as “OK,” as in Figure 173.
3. Click the Protocol button to open the Protocol Configuration window.
Figure 174. Data Link Layer
4. Select E1 CAS as the Span Type, and select the Switch Mode according to your
country in the E1 R2 Setting field, and click OK.
5. In the Trunk Configuration window, click the Trunk Properties button to open the
E1 Channel Configuration window.