User guide

Chapter 27: Microsoft Exchange Integration
MAXCS ACC 6.7.1 Administration Manual 355
Figure 164. Associating your “Exchange” codec profile to the IP address of Exchange
Server
6. Click the Add button in the IP Device Range panel.
7. Select the codec profile you just created specifically for Exchange.
8. Enter the IP address of the Exchange Server in both the From and To fields. Be sure
that this IP address does not fall into any other device range. (Check the IP Codec
tab and the IP Dialing Table tab.) If it does, reset that range into two ranges: one
that ends just before the Exchange Server’s IP address, and one that starts just after
the Exchange Server’s IP address.
9. In MaxAdmin, go to PBX > Voice Mail Configuration. In the Exchange Integration
panel, select Bridged Access to Exchange or Native VM Integration with
Exchange.
10. Click OK.
11. Restart all AltiGen services.
Note: After all AltiGen services are restarted, voice mail access may be unavailable for
1-2 minutes.