User guide

Chapter 26: System Report Management
336 MAXCS ACC 6.7.1 Administration Manual
Configure the parameters:
• Check Enable sending SNMP traps.
• Enter the SNMPv3 server address.
• Enter the SNMPv3 server port.
• Select a security level:
• No Authentication and No Privacy
• With Authentication but No Privacy
• With Authentication and Privacy
• Select an Authentication Method, and enter a password
• Select a Privacy Protocol, and enter a password.
• Configure traps:
• Memory usage exceeds This is sent when MAXCS detects that the lowest virtual
memory usage exceeds a specified percentage of physical memory configuration
within a 10-minute duration. Default value is 80%. The next trap will be sent after
the condition is cleared then occurs again. The minimum duration between any
two consecutive traps is 30 minutes
• Average CPU utilization exceeds This is sent when MAXCS detects its average
CPU utilization exceeds a specified percentage in any 10-minute duration. Default
value is 80%. The next trap will be sent after the condition is cleared then occurs
again. The minimum duration between any two consecutive traps is 30 minutes
• Hard disk usage exceeds This is sent when hard disk usage of MAXCS transi-
tioning from below threshold to on or above threshold is detected. Default value
is 80%. The minimum duration between any two consecutive traps is 30 minutes.