User guide

For a mobile phone using
MaxMobile Communicator, clear
all the Phrase check boxes.
Chapter 18: Mobile Extension Configuration
MAXCS ACC 6.7.1 Administration Manual 231
Figure 116. ExtensionAnywhere Configuration - MobileExtSP dialog box
• Name Enter the name of the person using the mobile phone.
• Target Phone Number—Enter the number of the mobile phone. This is used
when MAXCS makes a call through PSTN to the mobile phone. Do not include
the trunk access code.
• Caller ID—Enter the phone number of the mobile phone. This is for incoming
caller ID verification. MAXCS uses it to determine whether a call is from a mo-
bile extension. If the caller ID is matched, the mobile extension user will hear
a dial tone from the system, the same as an internal extension user hears when
the phone is off-hooked.
It's also used to find a mobile channel in the MaxMobile Communicator appli-
cation, and it is used in the MaxMobile Communicator login.
Note: When a MaxMobile Communicator user logs into MAXSCS, the assigned
extension number, extension password and cell phone number are
used as identification. First, MAXCS checks the extension number and
extension, then it uses the cell phone number to search the mobile
channel table. If MAXCS finds a channel's Caller ID is the same as the
cell phone number, it assigns this channel to the extension number.
The extension is allowed to log in as a mobile extension. If no channel
is found, the login fails.
• Mobile Trunk Allocation—select either Shared or Dedicated.
Shared—When selected, this mobile extension will share mobile trunk ports
with other mobile extension users. You must assign a mobile trunk Group ID to
this extension. The system will dynamically allocate a mobile trunk port within
this Group ID when the system calls out to this mobile extension number.