User guide

Chapter 18: Mobile Extension Configuration
226 MAXCS ACC 6.7.1 Administration Manual
MobileExtSP Board Overview
A simulated physical board (MobileExtSP board) is created when you install the MAXCS
Softswitch. You can configure this board with up to 1000 mobile extension ports. It
handles all systemwide mobile extensions.
Figure 113. MobileExtSP board diagram
T1, PRI, analog, and SIP trunks can be shared for regular incoming and outgoing calls
and mobile trunk connections.
A mobile trunk can be assigned a Group ID and mobile extensions can be assigned to
the appropriate group.
An analog trunk can be dedicated to one mobile extension user. A PRI trunk and SIP
trunk can only be shared by all mobile extension users.
Configuring the MobileExtSP Board
Note: For a Softswitch with a multi-gateway system, your Release 6.0 MobileExt config-
uration files are stored in the gateway in the following directory: \altiserv\sp\tri-
ton. After upgrading to Release 6.7, you need to manually move these files to the
Softswitch machine’s \altiserv\sp\MobileSP directory. Then reboot the Softswitch.
1. In the Boards window, double-click the MobileExtSP board. In the Board
Configuration window, double-click a channel group.