User guide

Chapter 17: AltiGen IP Phone Configuration
216 MAXCS ACC 6.7.1 Administration Manual
Figure 111. IP Phone Configuration window, General tab
The left side of the IP Phone Configuration window displays all the IP phone extensions
that have been set up in the system. The status "Inactive" means the Enable IP Exten-
sion box is checked for this extension in the Extension Configuration window, but there
is no IP phone logged in to the extension. The extension may be a physical extension
using an analog phone, a MobileExt, or a virtual extension.
After creating the IP extensions, you can set the following parameters on the General
tab:
Note: The Apply To button works with the following parameters: General, TFTP
Server field (Reset IP Phone and Boot Download options cannot be applied to
multiple extensions), Debug, and Display Workgroup Status (IP 705 and IP
600 phones).
Parameter Description
General
Lets you specify the IP address of the MAXCS system the IP phone is con-
nected to. Also see The version of firmware associated with the IP phone
is automatically displayed in the Version field.
To protect the configuration on the IP phone, check the Enable Configure
Password check box and assign a numerical password. When the user
presses the Menu button on the IP phone to access the phone configuration
menu, the user will need to enter the assigned password. You can use this
check box for two purposes:
• If you publish the configuration password to the user, only the phone
user would be able to change the phone configuration.
• If you do not publish the configuration password, you can block the
phone user from changing the phone configuration.
Default Trunk
Access Code
Lets you set the digit required to enable a user to return an outside call
from the Call Log. The default trunk access code can be the route access
code, if it is set in MaxAdmin.