User guide

Chapter 14: Out Call Routing Configuration
MAXCS ACC 6.7.1 Administration Manual 171
Working on Dialing Patterns
If your system is using a route access code, most likely you have one of the following
situations:
• Your area may have multiple 10-digit dialing area codes.
• Your area may have both 10-digit and 1+10 digit dialing in a same area code.
• Your system needs to borrow another system's trunk to make an outbound call over
an IP or tie trunk.
• You would like to block a dialing pattern in addition to system restriction setting.
Dialing patterns are exceptions. If you can, minimize the number of dialing pattern
entries. Most companies don’t need to create dialing patterns.
Creating a Dialing Pattern
1. Click the Dialing Pattern tab on the Out Call Routing Configuration window.
Figure 97. Out Call Routing Configuration, Dialing Pattern tab
2. Click Add.
3. Type in the prefix and pattern length, and click OK.
4. Assign routes to this prefix by selecting routes from the lists in the Route Priority
section of the Dialing Pattern tab.
5. If this is a restricted number or pattern, skip step 4 and select the Disallow this
dialing pattern check box.
Deleting a Dialing Pattern
Select the pattern you want to delete, and click the Delete button.