User guide

Chapter 12: Trunk Configuration
MAXCS ACC 6.7.1 Administration Manual 149
Triton T1/E1 Trunk Properties
To open a configuration dialog box for a Triton T1/E1 channel, do one of the following:
• If you’re in the Trunk Configuration window, select a Triton T1/E1 channel from
the trunk channels list, then click Trunk Properties, or just double-click the channel
in the list.
• If you’re in the Trunk View window, right-click the channel and select Channel
Properties.
Figure 83. Triton T1 Configuration dialog box
Following are the parameters for the Triton T1 Configuration dialog box:
Parameter Description
T1 robbed-bit signaling
Protocol
You can set Protocol to one of the following:
• E&M Wink Start (default)
• E&M Immediate Start
• Ground Start
• Loop Start
For signaling from one board to another, only E&M Wink Start is
supported. Loop Start, Ground Start, and E&M Immediate Start
protocols cannot be used for interfacing between two boards.
Dialing Delay
Specifies the delay, in milliseconds, after trunk seizure and before
digit dialing. This configuration will slow down the system transmit-
ting digits to the CO by a defined delay to avoid missing digits. Do
not change this value unless advised.
Caller ID and DID Collection
You can select the maximum time-out delays, in seconds, and the appropriate sequence
of symbols to be collected for Caller ID and DID.