User guide

Altera Corporation 39
Exercise 4: Analyze & Compare the Results in Hardware
Figure 29 shows the locations of SW4 and SW5 on the Stratix II EP2S180
DSP development board.
Figure 29. SW4 & SW5 on the Stratix II Professional EP2S180 DSP Development Board
10. To display the results in a MATLAB plot, click OK in the
SignalTap II Analysis dialog box (see Figure 28 on page 38), after
the SignalTap II logic analyzer finishes acquiring data and displays
the message “SignalTap II Analysis is complete.” Two MATLAB
plots display the captured data, in binary format, and in the radix
you specified. The MATLAB plots display the captured data in the
time domain.
SW4
SW5