User guide

Chapter Document
Version
Changes Made
Interlaken 2014.12.15 Made the following changes to the parameter tables:
• Added another value to the "TX channel bonding mode"
parameter in the "TX PMA Parameters" table.
• Added values to the "PCS TX channel bonding master" and
"Actual PCS TX channel bonding master" parameters in the
"TX PMA Parameters" table.
• Corrected the values to the "CTLE adaptation mode"
parameter in the "RX PMA Parameters" table.
• Added the "Enable Interlaken TX random disparity bit"
parameter to the "Interlaken Disparity Generator and
Checker Parameters" table.
• Changed the values to four parameters to "Off" in the
"Gearbox Parameters" table.
• Removed the "Enable embedded debug" parameter from the
"Dynamic Reconfiguration Parameters" table.
Gigabit Ethernet
(GbE) and GvE with
IEEE 1588v2
2014.12.15 Made the following changes:
• Added a figure description to the "Signals and Ports for
Native PHY IP Configured for GbE or GbE with IEEE
1588v2" figure.
10GBASE-R 2014.12.15 Made the following changes:
• Added a figure description to the "Signals and Ports of
Native PHY IP Core for the 10GBASE-R, 10GBASE-R with
IEEE 1588v2, and 10GBASE-R with FEC" figure.
1G/10 Gbps Ethernet
PHY IP Core
2014.12.15 Made the following changes:
• Changed the descriptions for 0x494 and 0x495, and added
0x4a4 bit 4 to the "GMII PCS Registers" section.
UG-01143
2015.05.11
Document Revision History for Previous Releases
9-13
Document Revision History for Current Release
Altera Corporation
Send Feedback