User guide

Figure 2-144: Using NativeLink with Third-Party Simulators
Specify EDA Simulator &
Simulator Directory
Perform
Functional Simulation
Debug Design &
Make RTL Changes
Does
Simulation Give
Expected Results?
Yes
Does
Simulation Give
Expected Results?
No
Simulation Complete
No
Run Quartus II
Analysis and Elaboration
Start Simulator, Compile
Design and Testbench
Load Design &
Run Simulation
Does
Simulation Give
Expected Results?
Yes
Complete the following steps to specify the directory path and testbench settings for your simulator:
1. On the Tools menu, click Options, and then click EDA Tool Options.
2. Browse to the directory for your simulator. The following table lists the directories for supported third-
party simulators:
UG-01143
2015.05.11
How to Use NativeLink to Specify Third-Party RTL Simulators
2-327
Implementing Protocols in Arria 10 Transceivers
Altera Corporation
Send Feedback