User guide

of the device. Consequently, you must route any signal that you want to observe to the top-level of
your design.
4. To monitor additional signals, highlight the desired instances or nodes in Instance, and right-click
Add wave.
5. Select Simulate and then Run.
6. Specify the simulation duration.
7. Complete the following steps to restart the simulation:
a. On the ModelSim-Altera Simulate menu, select restart, then click ok.
This action clears the existing waves.
b. Highlight run and select the appropriate options to run the simulation.
Related Information
Simulating the Transceiver Native PHY IP Core on page 2-322
How to Use NativeLink to Specify Third-Party RTL Simulators
The following figure illustrates the high-level steps for using the NativeLink with Third-Party EDA RTL
simulator.
2-326
How to Use NativeLink to Specify Third-Party RTL Simulators
UG-01143
2015.05.11
Altera Corporation
Implementing Protocols in Arria 10 Transceivers
Send Feedback