User guide

Parameter Range
RX word aligner mode
bitslip
manual (PLD controlled)
synchronous state machine
RX word aligner pattern length 7, 8, 10, 16, 20, 32, 40
RX word aligner pattern (hex) User-defined value
Number of word alignment patterns to achieve sync 0-255
Number of invalid data words to lose sync 0-63
Number of valid data words to decrement error count 0-255
Enable fast sync status reporting for deterministic latency
SM
On/Off
Enable rx_std_wa_patternalign port On/Off
Enable rx_std_wa_a1a2size port On/Off
Enable rx_std_bitslipboundarysel port On/Off
Enable rx_bitslip port On/Off
Enable TX bit reversal On/Off
Enable TX byte reversal On/Off
Enable TX polarity inversion On/Off
Enable tx_polinv port On/Off
Enable RX bit reversal On/Off
Enable rx_std_bitrev_ena port On/Off
Enable RX byte reversal On/Off
Enable rx_std_byterev_ena port On/Off
Enable RX polarity inversion On/Off
Enable rx_polinv port On/Off
Enable rx_std_signaldetect port On/Off
Enable PCIe dynamic datarate switch ports Off
Enable PCIe pipe_hclk_in and pipe_hclk_out ports Off
Enable PCIe Gen 3 analog control ports Off
Enable PCIe electrical idle control and status ports Off
Enable PCIe pipe_rx_polarity port Off
2-312
Native PHY IP Parameter Settings for Basic, Basic with Rate Match...
UG-01143
2015.05.11
Altera Corporation
Implementing Protocols in Arria 10 Transceivers
Send Feedback