User guide

Parameter Range
Transceiver configuration rules
Basic/Custom (Standard PCS)
Basic/Custom w/Rate Match (Standard
PCS)
PMA configuration rules basic
Transceiver mode
TX/RX Duplex
TX Simplex
RX Simplex
Number of data channels
1 to 96
Data rate
611 Mbps to 12 Gbps
Enable datapath and interface reconfiguration On/Off
Enable simplified data interface On/Off
Table 2-181: TX PMA Parameters
Parameter Range
TX channel bonding mode
Not bonded
PMA-only bonding
PMA and PCS bonding
PCS TX channel bonding master
Auto, n-1 (where n = the number of data
channels)
Actual PCS TX channel bonding master
n-1 (where n = the number of data channels)
TX local clock division factor 1, 2, 4, 8
Number of TX PLL clock inputs per channel 1, 2, 3, 4
Initial TX PLL clock input selection 0 (Depends on the Number of TX PLL
clock inputs per channel value)
Enable tx_pma_clkout port On/Off
Enable tx_pma_div_clkout port On/Off
tx_pma_div_clkout division factor Disabled, 1, 2, 33, 40, 66
Enable tx_pma_elecidle port On/Off
Enable tx_pma_qpipullup port (QPI) On/Off
Enable tx_pma_qpipulldn port (QPI) On/Off
UG-01143
2015.05.11
Native PHY IP Parameter Settings for Basic, Basic with Rate Match...
2-309
Implementing Protocols in Arria 10 Transceivers
Altera Corporation
Send Feedback