User guide

How to Implement the Basic, Basic with Rate Match Transceiver Configuration Rules in Arria 10
Transceivers
Before you begin
You should be familiar with the Standard PCS and PMA architecture, PLL architecture, and the reset
controller before implementing your Basic protocol IP.
1. Open the IP Catalog and select the Native PHY IP.
Refer to Select and Instantiate the PHY IP Core on page 2-2.
2. Select Basic/Custom (Standard PCS) or Basic/Custom w/Rate Match (Standard PCS) from the
Transceiver configuration rules list located under Datapath Options depending on which configura‐
tion you want to use.
3. Use the parameter values in the tables in Native PHY IP Parameter Settings for Basic, Basic with
Rate Match Configurations as a starting point. Or, you can use the protocol presets described in
Presets. You can then modify the setting to meet your specific requirements.
4. Click Finish to generate the Native PHY IP (this is your RTL file).
2-306
How to Implement the Basic, Basic with Rate Match Transceiver...
UG-01143
2015.05.11
Altera Corporation
Implementing Protocols in Arria 10 Transceivers
Send Feedback