User guide

Parameter Range
Enable tx_pma_div_clkout port On / Off
tx_pma_div_clkout division factor Disabled, 1, 2, 33, 40, 66
Enable tx_pma_elecidle port On / Off
Enable tx_pma_qpipullup port (QPI) On / Off
Enable tx_pma_qpipulldn port (QPI) On / Off
Enable tx_pma_txdetectrx port (QPI) On / Off
Enable tx_pma_rxfound port (QPI) On / Off
Enable rx_serialpbken port On / Off
Table 2-176: RX PMA Parameters
Parameter Range
Number of CDR reference clocks 1 to 5
Selected CDR reference clock 0 to 4
Selected CDR reference clock
frequency
For Basic (Enhanced PCS): Depends on the data rate parameter
For Basic with KR FEC: 50 to 800
PPM detector threshold 100, 300, 500, 1000
CTLE adaptation mode manual, triggered
DFE adaptation mode continuous, manual, disabled
Number of fixed dfe taps 3, 7
Enable rx_pma_clkout port On / Off
Enable rx_pma_div_clkout port On / Off
rx_pma_div_clkout division factor Disabled, 1, 2, 33, 40, 66
Enable rx_pma_clkslip port On / Off
Enable rx_pma_qpipulldn port (QPI) On / Off
Enable rx_is_lockedtodata port On / Off
Enable rx_is_lockedtoref port On / Off
Enable rx_set_locktodata and rx_set_
locktoref ports
On / Off
Enable rx_serialpbken port On / Off
Enable PRBS verifier control and
status ports
On / Off
UG-01143
2015.05.11
Native PHY IP Parameter Settings for Basic (Enhanced PCS) and Basic...
2-285
Implementing Protocols in Arria 10 Transceivers
Altera Corporation
Send Feedback