User guide

Parameter Value
tx_pma_div_clkout division factor 2
Enable tx_pma_elecidle port Off
Enable tx_pma_qpipullup port (QPI) Off
Enable tx_pma_qpipulldn port (QPI) Off
Enable tx_pma_txdetectrx port (QPI) Off
Enable tx_pma_rxfound port (QPI) Off
Enable rx_seriallpbken port Off
Table 2-170: RX PMA Parameters
Parameter Value
Number of CDR reference clocks 1
Selected CDR reference clock 0
Selected CDR reference clock frequency Select legal range defined by the Quartus II software
PPM detector threshold 1000
CTLE adaptation mode manual
DFE adaptation mode disabled
Number of fixed dfe taps 3
Enable rx_pma_clkout port Off
Enable rx_pma_div_clkout port On
rx_pma_div_clkout division factor 2
Enable rx_pma_clkslip port Off
Enable rx_pma_qpipulldn port (QPI) Off
Enable rx_is_lockedtodata port On
Enable rx_is_lockedtoref port On
Enable rx_set_locktodata and rx_set_locktoref
ports
Off
Enable rx_seriallpbken port Off
Enable PRBS verifier control and status ports Off
Table 2-171: Standard PCS Parameters
Parameters Value
Standard PCS / PMA interface width 20
2-276
Native PHY IP Parameter Settings for CPRI
UG-01143
2015.05.11
Altera Corporation
Implementing Protocols in Arria 10 Transceivers
Send Feedback