User guide

Native PHY IP Parameter Settings for CPRI
Table 2-168: General and Datapath Options
The first two sections of the Parameter Editor for the Native PHY IP provide a list of general and datapath options
to customize the transceiver.
Parameter Value
Message level for rule violations
error
warning
Transceiver configuration rules
CPRI (Auto)
CPRI (Manual)
PMA configuration rules
basic
Transceiver mode
TX/RX Duplex
Number of data channels 1-36
Data rate
614.4 Mbps
1228.8 Mbps
2457.6 Mbps
3072 Mbps
4915.2 Mbps
6144 Mbps
9830.4 Mbps
Enable datapath and interface reconfiguration Off
Enable simplified data interface On
Table 2-169: TX PMA Parameters
Parameter Value
TX channel bonding mode
Not Bonded / PMA Bonding Only / PMA and PCS
Bonding
TX local clock division factor 1
Number of TX PLL clock inputs per channel 1
Initial TX PLL clock input selection 0
Enable tx_pma_clkout port Off
Enable tx_pma_div_clkout port On
UG-01143
2015.05.11
Native PHY IP Parameter Settings for CPRI
2-275
Implementing Protocols in Arria 10 Transceivers
Altera Corporation
Send Feedback