User guide

Word Addr Bit R/W Name Description
0x4B1
0
R SEQ Link Ready When asserted, the sequencer is indicating that the
link is ready.
1 R SEQ AN timeout When asserted, the sequencer has had an Auto
Negotiation timeout. This bit is latched and is reset
when the sequencer restarts Auto Negotiation.
2 R SEQ LT timeout When set, indicates that the Sequencer has had a
timeout.
13:8 R SEQ Reconfig
Mode[5:0]
Specifies the Sequencer mode for PCS reconfigura‐
tion. The following modes are defined:
• Bit 8, mode[0]: AN mode
• Bit 9, mode[1]: LT Mode
• Bit 10, mode[2]: 10G data mode
• Bit 11, mode[3]: Gige data mode
• Bit 12, mode[4]: Reserved for XAUI
• Bit 13, mode[5]: 10G FEC mode
16 R KR FEC ability
170.0
When set to 1, indicates that the 10GBASE-KR
PHY supports FEC. Set as parameter SYNTH_FEC.
For more information, refer to Clause 45.2.1.84 of
IEEE 802.3ap-2007.
17 R KR FEC err ind
ability 170.0
When set to 1, indicates that the 10GBASE-KR
PHY is capable of reporting FEC decoding errors
to the PCS. For more information, refer to Clause
74.8.3 of IEEE 802.3ap-2007.
0x4B2
0:10 — Reserved —
11 RW KR FEC TX Error
Insert
Writing a 1 inserts one error pulse into the TX FEC
depending on the Transcoder and Burst error
settings. This bit self clears.
31:12 — Reserved —
0x4B5 to
0x4BF
Reserved for 40G KR Intentionally left empty for address compatibility
with 40G MAC + PHY KR solutions.
2-142
10GBASE-KR PHY Register Definitions
UG-01143
2015.05.11
Altera Corporation
Implementing Protocols in Arria 10 Transceivers
Send Feedback