User guide

Native PHY IP Parameter Settings for 10GBASE-R, 10GBASE-R with IEEE 1588v2, and 10GBASE-R
with FEC
Table 2-87: General and Datapath Parameters
The first two sections of the Transceiver Native PHY parameter editor provide a list of general and datapath
options to customize the transceiver.
Parameter Range
Message level for rule violations error, warning
Transceiver Configuration Rule 10GBASE-R
10GBASE-R 1588
10GBASE-R with KR FEC
Transceiver mode TX / RX Duplex, TX Simplex, RX Simplex
Number of data channels 1 to 96
Data rate 10312.5 Mbps
Enable reconfiguration between
Standard and Enhanced PCS
On
Off
Enable simplified data interface On
Off
Table 2-88: TX PMA Parameters
Parameter Range
TX channel bonding mode Not bonded
TX local clock division factor 1, 2, 4, 8
Number of TX PLL clock inputs per
channel
1, 2, 3, 4
Initial TX PLL clock input selection 0
Table 2-89: RX PMA Parameters
Parameter Range
Number of CDR reference clocks 1 to 5
Selected CDR reference clock 0 to 4
2-120
Native PHY IP Parameter Settings for 10GBASE-R, 10GBASE-R with IEEE...
UG-01143
2015.05.11
Altera Corporation
Implementing Protocols in Arria 10 Transceivers
Send Feedback