User guide

Parameter Value
Provide separate interface for each
channel
On / Off
Table 2-69: TX PMA Parameters
Parameter Value
TX channel bonding mode Not bonded
PMA-only bonding
PMA and PCS bonding
PCS TX channel bonding master If TX channel bonding mode is set to PMA and PCS bonding,
then:
Auto, 0, 1, 2, 3,...,[Number of data channels – 1]
Actual PCS TX channel bonding
master
If TX channel bonding mode is set to PMA and PCS bonding,
then:
0, 1, 2, 3,...,[Number of data channels – 1]
TX local clock division factor If TX channel bonding mode is not bonded, then:
1, 2, 4, 8
Number of TX PLL clock inputs per
channel
If TX channel bonding mode is not bonded, then:
1, 2, 3, 4
Initial TX PLL clock input selection 0
Enable tx_pma_clkout port On / Off
Enable tx_pma_div_clkout port On / Off
tx_pma_div_clkout division factor When Enable tx_pma_div_clkout port is On, then:
Disabled, 1, 2, 33, 40, 66
Enable tx_pma_elecidle port On / Off
Enable tx_pma_qpipullup port (QPI) Off
Enable tx_pma_qpipulldn port (QPI) Off
Enable tx_pma_txdetectrx port (QPI) Off
Enable tx_pma_rxfound port (QPI) Off
UG-01143
2015.05.11
Native PHY IP Parameter Settings for Interlaken
2-91
Implementing Protocols in Arria 10 Transceivers
Altera Corporation
Send Feedback