Specifications

1–12 Chapter 1: Using the NicheStack TCP/IP Stack
Software Development Flow
Using the NicheStack TCP/IP Stack - Nios II Edition Tutorial June 2011 Altera Corporation
1. Configure the FPGA on the development board by performing the following steps:
a. On the Nios II menu, click Quartus II Programmer.
b. In the Quartus II Programmer dialog box, on the File menu, click Open.
c. Browse to and open the <tutorial_files>\niosii_ethernet_standard_<board>\
niosii_ethernet_standard_<board>.sof SRAM Object File (.sof). Information
for the file appears in the Quartus II Programmer dialog box.
d. Verify Program/Configure is on, as shown in Figure 1–7.
e. Click Start to configure the FPGA on the development board.
1 If Start is disabled or if the USB-Blaster cable is not listed in the Hardware
Setup field, refer to the Introduction to the Quartus II Software manual for
more information about the Quartus II Programmer.
f. On the File menu, click Exit to close the Quartus II Programmer and return to
the Nios II SBT for Eclipse. If you receive a message that asks if you want to
save the changes to the chain1.cdf file, click No.
2. In the Nios II SBT for Eclipse, select the niosII_simple_socket_server_0 project in
the Project Explorer view.
3. On the Run menu, point to Run As and click Nios II Hardware to build the
program, download it to the board, and run it.
Figure 1–7. Quartus II Programmer Dialog Box