Specifications

Serial FlashLoader Support with Encryption Enabled Page 31
Using the Design Security Features in Altera FPGAsJune 2012 Altera Corporation
To encrypt the .sof file, refer to Step 7 in “How to Generate the Single-Device .ekp
File and Encrypt the Configuration File using Quartus II Software” on page 7.
j. Highlight FlashLoader and click Add Device (Figure 25).
k. Click OK. The Select Devices page appears.
l. Select the target FPGA that you are using to program the serial configuration
device.
m. Click OK.
5. Program the serial configuration device with the encrypted .jic file.
f For more information about programming the serial configuration device
or devices with the .jic file that you just created, refer to the procedure in
the Programming Serial Configuration Devices Using the Quartus II Programmer
and JIC Files section in AN 370: Using the Serial FlashLoader With the
Quartus II Software.
6. Program the key into the FPGA device.
1 To program the key to a single FPGA device, follow the steps in“How to
Perform Single-Device Volatile or Non-Volatile Key Programming Using
Quartus II Software” on page 20.
Figure 25. FlashLoader
Add the FlashLoader
bridge of the required
FPGA