User guide

Chapter 2: EthernetBlaster Communications Cable Administration 2–3
Resetting the Hardware
© June 2008 Altera Corporation EthernetBlaster Communications Cable User Guide
3. Enter the new Quartus II remote connection password in the New Password field
and again in the Confirm New Password field. Click Apply.
The EthernetBlaster communications cable restarts. When the status LED emits a
steady green light, the EthernetBlaster has successfully reset and the new password is
effective.
Resetting the Hardware
The EthernetBlaster communications cable reset button is located on the Ethernet port
side of the hardware. See Figure 2–3.
Use a small pointed object such as a paper clip to press the machine reset button to
restart and reset all values to the default factory settings. See Table 2–1 for a list of
factory default settings.
Figure 2–2. Change Quartus II Remote Connection Password Page
Figure 2–3. Machine Reset button
Table 2–1. Default Factory Settings
Setting Value
Connection Type DHCP
Host name acebXXXX (1)
Domain name Clear
Timeserver Name/IP Clear
ETHERNET
DC12V
Machine Reset Paper cli
p