Specifications

CHAPTER 1: INSTALLING ALTERA SOFTWARE
SETTING UP THE QUARTUS II SOFTWARE WITH A JTAG SERVER ON A NETWORK
17 ■ ALTERA SOFTWARE INSTALLATION AND LICENSING ALTERA CORPORATION
Setting up the Quartus II Software
with a JTAG Server on a Network
If you install the Quartus II software for Windows on a network drive and
have a JTAG server, you must set up the Quartus II software to allow the
JTAG server to run JTAG services.
To set up the Quartus II software to enable the JTAG server to run JTAG
services, follow these steps:
1. On Windows Start menu, click Run.
2. In the Run dialog box, type <drive>:\<Quartus II software system
directory path>\:jtagserver --install <username> <password>.
Where the <username> <password> are the username and password of
the JTAG server.
or
Install the Quartus II software on a local drive.
Using the 64-bit Version of the
Quartus II Software for Linux
If your project requires addressability of computer memory greater than
4 GB for command-line executables, such as quartus_map, quartus_fit,
quartus_sta, quartus_tan, and quartus_cdb, you can use the 64-bit version
of the Quartus II software for Linux. Compiling designs with the 64-bit
version of the Quartus II software requires more system memory and you
may notice an increase in compilation times if there is not sufficient physical
memory to accommodate the increased memory usage. You can mitigate
this effect by increasing the total physical memory on the system.
!
Administrator Privileges
You must have system administration (Administrator) privileges to set up the
Quartus II software to allow the JTAG server to run JTAG services.