User manual

Configuring the EPCS64 in

AS Mode (2/2)

1. Ensure that power is applied to the DE2-115 board.

2. Connect the supplied USB cable to the USB Blaster port on the

DE2-115 board.

3. Configure the JTAG programming circuit by setting the

RUN/PROG slide switch (SW19) to the PROG position.

4. The EPCS64 chip can now be programmed by using the

Quartus II Programmer to select a configuration bit stream file

with the .pof filename extension.

5. Once the programming operation is finished, set the

RUN/PROG slide switch back to the RUN position and then

reset the board by turning the power switch off and back on; this

action causes the new configuration data in the EPCS64 device

to be loaded into the FPGA chip.