User guide

SFSU - Embedded Systems Tutorial Nano- Electronics & Computing Research Lab
4
Altera Cyclone® IV 4CE115 FPGA device
Altera Serial Configuration device – EPCS64
USB Blaster (on board) for programming; both JTAG and Active Serial (AS) programming modes are
supported
2MB SRAM
Two 64MB SDRAM
8MB Flash memory
SD Card socket
4 Push buttons
18 Slide switches
18 Red user LEDs
9 Green user LEDs
50MHz oscillator for clock sources
24-bit CD-quality audio CODEC with line-in, line-out, and microphone-in jacks
VGA DAC (8-bit high-speed triple DACs) with VGA-out connector
TV Decoder (NTSC/PAL/SECAM) and TV-in connector
2 Gigabit Ethernet PHY with RJ45 connectors
USB Host/Slave Controller with USB type A and type B connectors
RS-232 transceiver and 9-pin connector
PS/2 mouse/keyboard connector
IR Receiver
2 SMA connectors for external clock input/output
One 40-pin Expansion Header with diode protection
One High Speed Mezzanine Card (HSMC) connector
16x2 LCD module