User guide

SFSU - Embedded Systems Tutorial Nano- Electronics & Computing Research Lab
34
9) When it has compiled, double click on “Program Device”.
a) Push the large red button on the FPGA board to turn on the power.
b) Programmer will open, and at the top left “USB Blaster” will appear. If it does
not, click on “Hardware Setup”. Select “USB Blaster” and click ok.
c) When “USB Blaster” appears next to “Hardware Setup” select “Start” and
watch the upper right corner as the design is implemented.
d) When the “Progress” bar has reach 100% you may test your design on the
FPGA board.