User guide

SFSU - Embedded Systems Tutorial Nano- Electronics & Computing Research Lab

Step 7: When the Verilog code is finished, and all assignments are done, you will be

ready to compile your design and program the device.

Step 8: At the top of the screen, select the “Play” button to begin the automatic

compilation process. Watch in the lower left screen as the compilation process occurs.

This may take several minutes.

(Step 7)

Step 9: When it has compiled, double click on “Program Device”.

a) Push the large red button on the FPGA board to turn on the power.

b) Programmer will open, and at the top left “USB Blaster” will appear. If it does

not, click on “Hardware Setup”. Select “USB Blaster” and click ok.

c) When “USB Blaster” appears next to “Hardware Setup” select “Start” and

watch the upper right corner as the design is implemented.

d) When the “Progress” bar has reach 100% you may test your design on the

FPGA board.