User guide

A–2 Altera Corporation
Cyclone III FPGA Starter Kit User Guide July 2010
Creating a Flash-Programmable POF File
2. Select the following settings:
● Programming File Type: Programmer Object File (.pof)
● Configuration Device: CFI_128MB
● Mode: Active Parallel
● File Name: Type the name of the flashable .pof to write
1 If you choose to overwrite the existing .pof, a warning
message occurs.
3. Under Input file to the convert, select Configuration Master under
SOF Data. Refer to Figure A–2.
1 Before moving to the next step, ensure that the setting for
the Configuration Device is CFI_128MB.
Figure A–2. Input File to Convert
4. Click Add File.
5. Choose the .sof you want to convert and click OK.
6. Select SOF Data and click Properties. The SOF Data Properties
window appears.
7. Select and type the following settings as shown in Figure A–3:
● Pages: 0
● Address mode for selected pages: Start
● Start address (32-bit hexadecimal): 0x020000