Users Manual

MUSIC 4: The purple light flashes quickly after 3 times (only music control mode, suitable for DJ music). When there is no music,
the LED light does not light.
Operation
Getting Started
• When you first connect the main unit to the mains socket via the AC adaptor, the main unit will be in Standby mode.
• Long press the POWER button on the unit or on the remote control to switch the unit ON.
Pairing Bluetooth Enabled Devices
1. Switching to Bluetooth mode. The blue indicator will flash slowly, indicating that the system has entered pairing mode and will be
searchable by your Bluetooth enabled device.
2. Activate your Bluetooth enabled device and select the search mode. “SBC24L”will appear on your Bluetooth device list. Select
“SBC24L” in the pairing list.
3.The blue indicator will light up solidly if pairing succeeds.
RCA - AUDIO L/R socket
Use the RCA cable to connect with audio output socket of the connected audio device, such as a media player, to the unit's AUDIO
L/R socket.
HDMI (ARC) socket
The ARC (Audio Return Channel) function allows you to send audio input from an ARC-compliant TV to an ARC-compliant audio
device (e.g. soundbar) without the need for an additional audio cable connection.
To enjoy the ARC function, make sure the soundbar main unit's HDMI socket is connected via HDMI cable (not included) to the
HDMI (ARC) socket of your ARC-compliant TV. Then just use your TV remote control to adjust the volume output (VOL+/–and
MUTE) of the connected audio device.
NOTE:
• Your TV must support the HDMI-CEC and ARC, and the HDMI-CEC and ARC must be set to On. Make sure the HDMI cable you
use can support the ARC function. The setting method of HDMI-CEC and ARC may different depending on the TV. For details about
ARC function, please refer to the TV's instruction manual. HDMI-CEC will be called different names by different manufacturers.
Please refer to your TV's instruction manual for details on setting up HDMI-CEC and ARC.
Optical socket
Remove the protective cap from the OPTICAL socket, then connect an OPTICAL cable (not included) to the TV’s OPTICAL OUT
socket and the OPTICAL socket on the unit.
TIP: Make sure the audio setting of your source player (e.g. DVD player, game player, TV) is set to PCM with optical output.
LED Indication
When switch the unit on, all the lights are on by default. Press the “LED ON/OFF” on the remote control to switch LED mode.
Press once, turn off the white strobes.
Press twice, turn off all the lights.
Press three times, turn on all the lights.
Install LED Strip Light Kit
1. Insert the end of USB cable to the 5V out port of soundbar
2. Connect another end of USB cable with IR controller.
3. Connect the 4 Pin Plug of LED strip light with IR controller.(Note:The arrow must be connected to the same level.If not, it won’t
work. )
4. Press the button on remote to control LED strip light.
Remark：
-If you want to cut this strip light, please cut the LED strip through the lines marked on it. Led strip light can be cut between every 3
LEDs without damaging any of the rest strips. Do not roll the light when using.
-The strip lights are non-waterproof, suitable for indoor use.
-Please make sure the surface you intend to stick the LED strip light is clean, flat and dry.
-Please don't stick the lights to metal surface that conductive. It may cause a short-circuit on the strip light.