Specifications

c ) If you are using EMM386 or a similar memory manager, exclude this region in the
memory manager call, e.g. for EMM386 the call
DEVICE=EMM386.EXE X=D000-D4000
excludes 16 kB starting at $D000
d) Configure the base address on the PCBoardCard for the chosen 16 kB region
with jumpers S1-1 to S1-5 (see table 1)
J3 Master/Slave setting:
J3 inserted: Board is Slave (Slot 2 and 3)
(doesn`t work with altec Bootoption!)
J3 not inserted: Board is Master (Slot 0 and 1) *
The altec boot option only supports slots 0 and 1. The AWARD CardWare software
supports slots 0 - 3.
Note: J3 switch only necessary for the use of a second PCBoardCard.
e) Activate the BIOS extension (boot option) on the PCBoardCard if required with
jumper S1-6
f) Switch on the PC; when the message
“altec PCBoardCard BIOS Ver “
“press <ALT-S> for setup”
appears, press ALT-S in order to configure the PCBoardCard as required.
S1
. . . . . .
6 5 4 3 2 1
Position
5 4 3 2 1
C000 0 0 0 0 0
C200 0 0 0 0 x
C400 0 0 0 x 0
C600 0 0 0 x x
C800 0 0 x 0 0
CA00 0 0 x 0 x
CC00 0 0 x x 0
CE00 0 0 x x x
D000 0 x 0 0 0
D200 0 x 0 0 x
D400 0 x 0 x 0
Position
5 4 3 2 1
D600 0 x 0 x x
D800 0 x x 0 0
DA00 0 x x 0 x
DC00 0 x x x 0
DE00 0 x x x x *
E000 x 0 0 0 0
E200 x 0 0 0 x
E400 x 0 0 x 0
E600 x 0 0 x x
E800 x 0 x 0 0
Position
5 4 3 2 1
EA00 x 0 x 0 x
EC00 x 0 x x 0
EE00 x 0 x x x
F000 x x 0 0 0
F200 x x 0 0 x
F400 x x 0 x 0
F600 x x 0 x x
F800 x x x 0 0
FA00 x x x 0 x
FC00 x x x x 0
FE00 x x x x x
Base Address
S1-
Jumper array S1:boot address setting
Position 6 closed - Boot option enabled *
open - Boot option disabled
. . . . . .
J3
.
x = open 0 = closed * = factory setting
Table 1: Jumper array S1
Base Address
S1-
Base Adress
S1-
Table 2: Jumper array J3