User guide

2.2.2 Installation instruction for the Lite CopyStation module
Hardware Installation:
To install your Lite CopyStation module into you PC, shut down the PC first and disconnect
it from the power network.
Open your PC and install the lite CopyStation module into a free 5.25“ bay.
The Lite CopyStation module is to be powered by using the two SATA power connectors
that can be found at the back side of the module. You might either connect two free SATA
power plugs from the power supply of the PC, or you might use the provided 5.25“ power
adapter.
Notice that the Lite CopyStation needs to be powered separately, as it does not receive its
power via the USB connection.
Usually, both boards of the Lite CopyStation module are to be connected to the main board
of the PC through the two internal USB cable that have been shipped along with the
module. Alternatively, the module can also be connected by using the standard USB
cables.
In case the two internal cables are used, care needs to be taken to not use a wrong
polarity. Otherwise the Lite CopyStation module or the PC mother board might get
destructed!
The connection layout of the USB header for the internal USB cable connection left to
standard USB-B type socket at the back of the Lite CopyStation module is looking as
follows:
The connection layout of the USB header found on the mother board are usually looking as
illustrated by the next picture. Please compare this layout with the layout shown in the
users manual of your motherboard and check whether both are equal.
9/61