User guide

2.3.5 Operation in stand alone mode
2.3.5.1 Introduction to stand alone mode
Stand alone mode allow simple operations such as copying, verifying and copying followed by
verifying.
In stand alone mode, the source of the data is always a master card whose contents is either
copied to the destination cards or used to verify the data on the destination cards. The destination
cards must have exactly the same storage capacity as the master card which is currently being
used.
2.3.5.2 Menus in stand alone mode
The function of the three operating buttons below the LC-Display is context dependent. The current
function is shown at the bottom edge of the display. The “Run” function is used to start a copy
operation. The “Menu”function takes you to the settings for the copy operation. Within menus, use
the left and right buttons for navigating and the center button for selecting.
Choose the required operation („Write“, „Verify“ or „Write and Verify“), press the center button and
then press the left button „Run“to start the chosen operation. While choosing the required
operation, the background illumination of the LC display is cyan (light blue).
16/61