User guide

2.3.4.2 LED colors and operating mode
The colors of the LEDs next to the card slots indicate the different operating states of
the IQ CopyStation as follows:
Green: An operation was successfully carried out on the card in this slot.
Yellow/orange (permanently lit): The card in this slot was successfully initialised but not
yet processed.
Yellow/orange (blinking): An operation is taking place on the card in this slot. Do not
remove the card from the slot during this phase.
Red: An error has been detected with the card in this slot.
LED not lit: No card inserted.
Red blinking: Internal hardware error.
2.3.4.3 LC display colors and operating modes
The background color of the LC display changes according to the operating mode of
the IQ CopyStation. The different colours and modes are as follows (see also chapter
3.2).
Cyan (light blue): The IQ CopyStation has just been switched on and initialized. In stand
alone mode, the user menu is shown at the bottom edge of the display. In host based
mode, the text „Host controlled“ is shown; in addition, the device ID assigned by the
PowerSoftware is shown at the bottom right of the display.
Green: An operation has been finished successfully.
Yellow: The IQ CopyStation is currently carrying out an operation.
Red: An error has occurred during an operation; the operation was cancelled.
2.3.4.4 Inserting the memory cards
Please note the following when inserting memory cards in the IQ CopyStation:
The memory cards must be inserted into the slots with the contacts towards you (see figure on the
next page).
Attention: To allow you to copy to the cards, the write protect switch on the card (if fitted) must
not be in the locked position.
15/61