User guide

Notice that (as shown) there are usually two USB ports unified within one 2x5 pin header.
– In case the pinout of the USB headers on the mother board does not match the one shown
above, the pinout of one end of the internal USB cables needs to be changed according to
your mother board configuration. The coding of the used colors is as following:
· red: +5V
· white: D-
· green: D+
· black: GND
Changing the cable configuration is rather easy by carefully pressing down the spring of the
contact to be removed using a needle. Then the contact can be removed from the
connector body by pulling it at the cable:
After the contact has been removed, the spring needs to be bent back slightly:
Now, the contact can be reinserted into the connector body at the right position. The pin
needs to be pushed into the connector body until the spring is locking it so that it cannot be
pulled out again.
– The following picture shows the internal USB cables being attached to the Lite CopyStation
module. When connecting the cable, take care of the right polarity by using the same
assignment of the cable colors.
10/61