Product data

.
c
Start-up
DALI Manual | 08-2013 | en
73 / 93
Installation
The DALI circuit is installed using standard installation material for mains voltage. The mains voltage and DALI line
may be routed in the same cable. There is therefore no need for a separate bus line, but one can be used if required.
Figure: Wiring diagram
DALI USB is needed only for set-up with masterCONFIGURATOR and can then be removed.
Installing and connecting DALI GC
Standard switches can be used for installing DALI GC. DALI GC is installed directly in a flush-mounted box,
underneath or behind the light switch. Power is supplied to DALI GC via the bus line. It must not be connected to the
ac power supply. The switches are connected directly to DALI GC (floating make contacts).
Turn rotary switch to position 1
→ Group 1 is assigned to Switch T1
→ Group 2 is assigned to Switch T2