Product data

.
c
DALI multi controller: DALI MC
DALI Manual | 08-2013 | en
37 / 93
Table: Explanation of parameters for functions
Function Description
1) Push-button:
short or long = 1 * command X
Briefly pressing or holding down the push-button will send command X one
time.
2) Push-button:
short = 1 * command X,
long = 1 * command X then 1 *
command Y
3) Push-button:
short = 1 * command X,
long = 1 * command X then
repeatedly command Y
4) Push-button:
short = 1* command X,
long = repeatedly command Y
5) Push-button (toggle):
short or long = toggle between
command X and Y
Briefly pressing or holding down the push-button will alternate between sending
commands X and Y.
6) Push-button (toggle):
short or long = toggle between
command X and Y,
lighting-based
Briefly pressing or holding down the push-button will alternate between sending
commands X and Y. The command sent in each case depends on the status of
the lighting:
7) Push-button (dimming key):
short = toggle between command
X and Y,
long = dimming, lighting-based
SwitchDIM mode
8) Switch:
close = command X,
open = command Y
9) Changeover switch:
close = command X,
open = command Y,
lighting-based
Each time the switch is pressed, the commands X and Y are sent in alternating
order. The command sent in each case depends on the status of the lighting:
Briefly pressing the push-button will send command X one time.»
Holding down the push-button will send command X once, and then
command Y once.
»
Briefly pressing the push-button will send command X one time.»
Holding down the push-button will send command X once, and then
command Y repeatedly.
»
Briefly pressing the push-button will send command X one time.»
Holding down the push-button will repeatedly send command Y.»
If the lighting was previously switched off, command X is sent.»
If the lighting was previously switched on, command Y is sent.»
Briefly pressing on the dimming key will alternate between sending
commands X and Y. The command sent in each case depends on the
status of the lighting.
»
If the lighting was previously switched off, command X is sent.»
If the lighting was previously switched on, command Y is sent. Holding
down the dimmer switch dims or brightens the lighting.
»
When the switch is closed, command X is sent.»
When the switch is opened, command Y is sent.»
If the lighting was previously switched off, command X is sent.»
If the lighting was previously switched on, command Y is sent.»