Product data

DALI group controllers: DALI GC & GC-A

DALI Manual | 08-2013 | en

27 / 93

Figure: Programming mode with deletion of addresses

Selecting luminaires

To attach a luminaire to a group, the luminaire must be selected first.

Assigning a selected luminaire to a group

If a luminaire is assigned to a certain group it reacts to fade commands that come from momentary switches of the

same group. The group assigned can be stored in the selected DALI device.

I NOTICE

In programming mode the system first searches for available DALI devices in the DALI circuit. The devices are

addressed as follows:

In programming mode with deletion all devices will be automatically addressed

In programming mode without deletion only newly detected devices are addressed

During the search operation all the detected luminaires are faded to maximum. When the search has been

completed one luminaire (the one selected) will remain at maximum and all the others will be faded to the lowest

value.

Choose a button of the momentary switch

Press button briefly to select a luminaire

→ Selected luminaire is faded to maximum

→ All other luminaires are dimmed to minimum

Press button again to select another luminaire

I NOTICE

A single luminaire can contain more than one device. If this is the case all devices in the luminaire must be selected

separately.

The luminaires are selected in the sequence in which they are found. When you come to the last luminaire in the

sequence, the next one selected will be the first luminaire in the sequence again. A selected luminaire can now be

assigned to a group.

Make sure that the right luminaire is selected

Choose a button that is assigned to the right group