User manual

User Manual of Hikvision iVMS-4200 v2.0
41
4.2 Configuring Tampering Alarm
Purpose:
A tampering alarm is triggered when the camera is covered and the monitoring area cannot be viewed.
The linkage actions, including alarm output and client action can be set.
Steps:
1. Open the Event Management page and click the Camera Event tab.
2. Select the camera to be configured and select Tampering Alarm as the event type.
3. Check the checkbox Enable to enable the function of tampering alarm.
4. Select the arming schedule template from the drop-down list.
If you need to edit or customize the template, see Configuring Arming Schedule Template.
5. Select the triggered camera. The image or video from the triggered camera will pop up or be
displayed on the Video Wall when tampering alarm occurs.
6. Click-and-drag the mouse to draw a defined area for the arming region.
7. Drag the slider on the sensitivity bar to adjust the tampering alarm sensitivity.
8. Check the checkboxes to activate the linkage actions. For details, see Table 4.2 Linkage Actions for
Tampering Alarm.
9. Optionally, click Copy to… to copy the event parameters to other cameras.
10. Click Save to save the settings.
Table 4.2 Linkage Actions for Tampering Alarm
Linkage Actions
Descriptions
Alarm Output
Enable the alarm output function. Select the alarm output port and the
external device connected to the port can be controlled.
Audible Warning
The client software gives an audible warning when alarm is triggered.
Email Linkage
Send an Email notification of the alarm information to one or more receivers.
Alarm on E-map
Display the alarm information on the E-map.
Alarm Triggered
Pop-up Image
The Image of the triggered camera pops up when alarm is triggered.