User`s guide

5
English
Setting Up the SoundBlade
Before using the SoundBlade for the rst time, you must rst pair it
with a Stereo Bluetooth-enabled mobile phone or computer. After you
complete pairing, the wireless speaker system will be ready to play
music as well as make and receive calls.
1. Open the rear door of the SoundBlade by depressing the rear door
release button. Note that the rear door doubles as a stand for the
SoundBlade.
2. Open the two battery compartments at the rear of the
SoundBlade. Insert 6 AA batteries into the SoundBlade, three in
each battery compartment. Close battery compartment doors.
With 6 AA batteries, The SoundBlade can provide up to 24 hours
of operation time and  days of standby time, if the Bluetooth
feature is not active.
–OR–
Plug in the AC power adapter between the SoundBlade and a wall
power outlet.
. Press and hold the button on the SoundBlade until you hear a
pair of low/high tones (approximately 1 second). (NOTE: Tones do
not occur if the AUX IN is being used.)
4. Release the button. The blue light will ash intermittently and
you will hear a series of double beeps followed by low tones.
(NOTE: Tones do not occur if the AUX IN is being used. Phone
cannot be paired if the AUX IN is being used.)
5. Press and hold the button on the SoundBlade until you hear a
low/high tone combination play (approximately  seconds).
6. Release the button. You will hear another pair of low/high tones
and the light will begin to alternately ash red and blue. The
SoundBlade is now in pairing mode.
7. Power on your mobile phone.
8. Turn on your mobile phone’s Bluetooth functionality and ensure
that your mobile device is visible to other Bluetooth devices.
(The exact way you accomplish this task will vary by phone
manufacturer. Please refer to your mobile phone user guide for
specic instructions.)
9. Make sure your phone is within 1 meter ( feet) of the SoundBlade.
10. On your mobile phone, add a new Bluetooth device. (Please refer
to your mobile phone user guide for specic instructions.)
11. Your mobile phone should automatically begin to look for nearby
Bluetooth devices. Once your mobile phone has found the
SoundBlade, select it from the list presented to you. (Please refer
to your mobile phone user guide for specic instructions.)
12. Ensure that the light is still alternately ashing red and blue. If not,
repeat step 4.
1. Enter 0000 as the passcode on your mobile phone.
14. Your mobile phone should now be paired with the SoundBlade.
You’ll hear a high-pitched tone from the speaker system as
conrmation.
15. Be sure to choose both Stereo Headset and Hands Free services
on your mobile phone. When you are nished, you should hear
a series of high-pitched tones from the SoundBlade indicating a
successful connection. (Please refer to your mobile phone user
guide for specic instructions.)
Using the SoundBlade with a PC
The procedure for pairing and using the SoundBlade with a Bluetooth-
enabled computer is very similar to that for using the SoundBlade with
a mobile phone. Most operations on the SoundBlade are the same.
The only real differences will be the specic actions you take on your
PC, which will vary by computer manufacturer. Please consult your
computer’s user guide for specic details.