User guide

16
If you or a friend has an iPhone, iPod, non-iPod MP3 player or other
non-docking audio device, you can enjoy it through your Altec Lansing
Mix speaker system as well. Just connect it via the AUX 1 or AUX 2 jack.
Here’s how:
1 Locate one of the two 3.5 mm
stereo cables ( included).
2 Plug one end of the stereo cable
into your device.
Your device should have either a
headphone or LINE OUT jack for you
to plug into.
3 Plug the other end of the stereo
cable into your speaker system’s
AUX 1 or AUX 2 jack.
The AUX jacks are located on the top of the speaker system next to
the handle.
4 Select “AUX 1” or “AUX 2” mode.
Press the “SOURCE” button on your speaker system or the clip-on
remote until “Auxiliary Input 1” or “Auxiliary Input 2” appears on the
speaker system’s LCD.
5 Turn on your device and start playing it.
6 Adjust the volume.
Use the
knob on the speaker system to adjust the volume. Or, use
the “+” and “–” buttons on the clip-on remote.
NOTE You may need to adjust the device volume also. Your device’s
volume should be set to approximately ¾ volume.
Whenever you turn on your Altec Lansing Mix speaker system, the Altec
Lansing logo will appear for approximately 3 seconds followed by a
personalized message, if you’ve set one. The Mix comes with no preset
power-on message. To create a personalized message, just follow these
instructions:
1 Enter the Message Screen Edit Mode.
Press and hold the “SOURCE,” “EQ,”
and buttons. All four
buttons must be pressed at approximately the same time while the
Altec Lansing logo is displayed. The following message will appear on
the LCD: “Add a personal message by selecting letters with the track
buttons and rotary control.”
2 Add your personal message.
Rotate the
knob until the desired letter, number or symbol is
displayed. Press the
button to make your selection and move to
the next space. Continue this process until your entire message is
displayed.
3 Exit the Message Screen Edit Mode.
Press the
knob to save the message and exit the Message Screen
Edit Mode.
How to Delete a Personalized Message
1 Enter the Message Screen Edit Mode.
Press and hold the “SOURCE,” “EQ,”
and buttons. All four
buttons must be pressed at approximately the same time while the
Altec Lansing logo is displayed. The following message will appear on
the LCD: “Add a personal message by selecting letters with the track
buttons and rotary control.”
Listening to Additional iPhone, iPod, Non-Docking iPod or Other Audio Devices